ENVIROSHEET

Self-adhering sheet membrane waterproofing.

A composite sheet waterproofing membrane, ENVIROSHEET provides an easy means of installing a uniformly thick waterproofing membrane on both horizontal and vertical surfaces to protect against the infiltration of water. ENVIROSHEET is produced at a factory controlled thickness to provide a uniform 60-mil (1.5 mm) application and consists of 56-mils of rubberized asphalt and a 4-mil cross-laminated, polyethylene carrier film. The two components are laminated together under strict quality-control procedures to produce an extremely tough waterproofing barrier.

 

Envirosheet-800x300

 

    Overview
    ENVIROSHEET membrane is supplied in 200 square foot rolls, 36” (914 mm) wide by 66.7’ (20.3 m) long. The rubberized asphalt is covered with release paper which is removed prior to installation. The membrane is cold-applied and self-adheres to a properly prepared and primed substrate. A cold-weather version;

    ENVIROSHEET LT  is available for applications where the ambient temperatures will be between 25°F (-4°C) and 60°F (16°C).

    ENVIROSHEET membrane is ideal for:
    Waterproofing concrete, masonry block, and wood surfaces. It can be applied to foundation walls, tunnels, utility vaults and earth sheltered structures. It can also be used to waterproof split-slab construction, both above and below-grade, such as plaza decks, balconies, and parking decks. Interior uses may include mechanical rooms, laboratories, kitchens, and bathrooms. ENVIROSHEET membrane is typically not recommended for under slab applications and can not be used for property line applications.

    ENVIROSHEET requires the use of a substrate primer, detailing mastics, and a protection board for all applications. Concrete surfaces must be cured properly and dried a minimum of 7 days for normal structural concrete and 14 days for lightweight structural concrete or non-vented pan decks. ENVIROSHEET should not be applied in freezing temperatures or to damp surfaces.
    Featured Products

    200x147_Envirosheet

    ENVIROSHEET
    A self-adhering composite sheet waterproofing membrane, ENVIROSHEET consists of 56-mils of rubberized asphalt and a 4-mil cross-laminated, polyethylene carrier film. The two components are laminated together to produce an extremely tough waterproofing barrier.

     

     

    200x147_M2000-LiquidMastic

    M-2000 LIQUID FLASHING
    A single-component, trowel-grade moisture cured polyurethane mastic, M-2000 LIQUID FLASHING is used with CETCO Waterproofing Systems to detail primarily at membrane terminations, around horizontal deck penetrations and transitions, over grouted concrete form-tie holes, and provide fillets to inside wall corners. Available in 18.9 Liter (5-gallon) pails.

     

     

    200x147_Waterstop-RX

    WATERSTOP-RX®

    An active, flexible strip concrete construction joint waterstop, WATERSTOP-RX provides a strong positive seal by expanding upon contact with water. Proven effective on projects worldwide for over 20 years, Waterstop-RX is designed for both continuous and intermittent hydrostatic conditions. WATERSTOP-RX is available in multiple configurations.


    CETCO